Setseal 22
Previous product
Next product
Setseal 44
 

Setseal
AW

GENERAL-PURPOSE CONCRETE CURING COMPOUND BASED ON WATERBORNE ACRYLIC COPOLYMER
 
Advantages:
  • Recoatable
  • Non-degradable, single component
  • Enhanced concrete durability
  • Increase the surface abrasion
  • UV resistance
  • Helps achieve concrete desired strengths
  • Minimizes potential surface cracking and shrinkage
  • Promotes a harder dust free surface
  • Can be spray applied to reduce labor cost
  • Non toxic
Description:

Setseal AW is a single component, acrylic resin-based coating designed to impregnate concrete surfaces combining the benefits of a curing aid and hardener.

Setseal AW is designed to overcome the drawbacks of many commonly used curing membranes that tend to provide a limited service life following the curing period of new concrete. It has good abrasion resistance and is compatible with several types of coatings.

Usage

Setseal AW is mainly used for newly cast concrete and cementitious surfaces to retain sufficient moisture to ensure full hydration of the cement. Typical application areas include.

  • High rise construction to eliminate water curing
  • Runways and roads
  • Roof decks
  • Retaining walls
  • Irrigation canals
  • General floor slab and columns
  • All cement-based colored plasters

Materials Supplied

Setseal AW is available in 5 gal (19 litre) containers, 275 gal (1,041 litre) and 330 gal (1,249 litre) IBC totes. 

Coverage

The recommended coverage rate is 120 - 200 ft² per gal (3 - 5 m²/litre).

Storage

Store in a dry area out of direct sunlight between 41°F and 95°F (5°C and 35°C).

Shelf Life

Setseal AW has a shelf life of 12 months from the date of manufacture if stored in proper conditions in un-opened drums.

Application Instructions

Setseal AW should be spray applied as soon as possible to the fresh concrete, provided that the surface water has evaporated. Do not apply if bleed water is forming, or is present on the concrete surface.

Stir Setseal AW well before use to ensure even pigment dispersion. Setseal AW should be spray applied, the spray nozzle should be held approximately 18” (457 mm) from the concrete surface and passed back and forth to ensure complete coverage. Pump pressure should be maintained to give an even, fine spray.

The applied film should be protected from rain for at least 3 hours; care should be taken to ensure that the film is not broken. 

In the case of formed concrete, Setseal AW should be applied immediately after de-shuttering. In such a case the concrete surface must be dampened with clean water prior application of Setseal AW.

HEALTH AND SAFETY

Setseal AW should not come into contact with skin or eyes. In case of accidental splashes to the eyes, immediately flush with plenty of water and seek medical attention. Suitable protective gloves and goggles should be worn.

GENERAL GUIDANCE

This data sheet is for general guidance purposes only and may contain information that is inappropriate for certain conditions of use. Accordingly, all recommendations and suggestions are made without guarantee. Further information is available from our Technical Department.



Download file




Connect with Don Construction Products


  Complaints Record Form

  Customer Satisfaction

Name *
Email *
Phone
Address
Subject
Request  
Security Code *

Don Construction Products Inc.

Headquarters
2826 Lineberger Industrial Dr.
Lancaster, SC 29720

Tel: +1 803 286 5430
Fax: +1 803 286 5432